Before putting the finished edge on sink cut outs, it is important to use these Overhang Trim bits to remove most of the material and leave only 1/8" of top for your Round Over, Ogee, Bevel or Bull Nose bits to cut. This technique results in a much better finish and longer bit life. Specially formulated carbide is ideal for fabricating solid surface materials. Use these bits in your hand-held router.
• Cuts most material in sink openings to produce a better finish cut • Features non-marring synthetic bearing to protect finished edges • Cuts all solid surface materials • Use in hand-held portable routers
• Cuts most material in sink openings to produce a better finish cut • Features non-marring synthetic bearing to protect finished edges • Cuts all solid surface materials • Use in hand-held portable routers
Ideal For: Overhang trim of solid surface bowl"
data-product-image-url="https://www.wurthbaermachinery.com/images/P/85-255_1.jpg"
data-insert-after="" defer>
![Freud 1/2" Overhang Trim and Cut Out Bits, 3" Length, 85-255](https://www.wurthbaermachinery.com/images/P/85-255_1.jpg
"Freud 1/2" Overhang Trim and Cut Out Bits, 3" Length, 85-255")
